Click to view attachment
Does anyone know what size of Allen key I have to use to mount the tiny rubber wheel inside of my Aquatica housing for my Canon 5D that is for the power on/off? It fell off a couple of days ago.
Please see attached image.

Just pick up a set of small size allen wrenches then you're covered for most housing fasteners. Like 1.5mm to 6mm. Not sure what size for this one application but there's usually several controls & stuff on housing that require allens.

I have those sizes but the 1,5 mm is still too large. I don´t think Aquatica use mm, I guess it´s inches. I can´t find any smaller size than 1.5 mm here in Sweden. If I get the right size, it´s easier to order over the internet. Aquatica should have a service kit, but I contacted them a few weeks ago and there´s still no answer from them.

.050 inch

Aquatica is manufactured in Canada. I suggest that the part is metric. Try contacting Aquatica or a dealer: Aquatica Site.
Bob

Thanks for your answers, problem solved!

/Marco

Hi Marco, send me a private e-mail with your address and i'll put one in the mail for you, they are not metric BTW,

Thanks Jean! I have sent you a private e-mail.

/Marco

I'll take care of it Monday when i'm back at the office

Mea culpa
Bob

This is what service is all about, I had the same response from Aquatica with a dome lock for my housing. Great!